¶ LED Light
1. Disconnect the main power. Remove the 4 screws on the right cover by knob wrench and remove the right cover. Figure 1.8-1 & 1.8-2
2. Disconnect the cable adapter that highlighted in figure 1.8-3 (trace the cable to find the adapter). Follow the steps showing in Figure 1.8-4, press the buckle and separate the cables.
|
|
|
3. Use 5.5mm socket driver to remove the 4 nets showing in Figure 1.8-5 & 1.8-6. Notice: mind dropping the washers off.
|
|
4. Below is the upper LED light, use 2.5mm hex driver to remove the 2 screws and separate LED light with the mounting. Then install the new light, and make sure the LED light is flush with the mounting. Same way to deal with the side LED light. Figure 1.8-7
5. Same way to replace the lights in right side. Then, perform the reverse operation from step 3 to 1 for recovery. Connect the power and test.