¶ E368 - E Motor driver error
1. Check if the cable connection of L&R thermistor is fine. (When the temperature sensor cable connection is open-circuited, the screen will display the maximum temperature of 1100℃)
- Power printer off, take extruder assembly off.
- Use 2.0mm hex screw driver to remove the 4 screws and take black cover off.
- Re-plug the cable connector of motor.（Figure - 2）
2. Check if the driving gear or idle gear got stuck. Check if the driving gear got stuck in gear box.
3. Re-plug J10 & J11 in main board. Re-plug the 2 feed motor driving board as well. （Figure - 3）。
4. If issue persists, please contact with INTAMSYS service team.