¶ 3.5 The Idle gear (Feeding Filament)
1. If the feeding gears were wrapped with debris of filament, they need to be cleaned for maintenance.
2. Take the extruder assembly off the machine. (the cable support hot-plug)
3. Remove the 4 screws on the transparent cover with 1.5 mm Allen-Key and remove the cover. Figure 3.5-1
4. Carefully use a tweezer or little plier to take the right idle gear out, then clean the driving and idle gear with a hand-air-blower or else. (The left driving gear is fixed) Figure 3.5-2
